Repair & Remediation Services for FRP Tanks, Vessels & Industrial Systems
When a hazardous liquid system shows signs of deterioration, the margin between a manageable repair and an extended shutdown is almost always time. American Fiberglass Services runs both a licensed field crew and a full fabrication shop in Phoenix — which means we can assess the damage, fabricate what's needed, and put certified technicians on your site without the delays that come from coordinating multiple contractors.
Our technicians are trained for confined space entry, hazardous materials handling, and MSHA requirements, with extensive experience in mines, power plants, water treatment facilities, and industrial processing sites across Arizona, California, Utah, New Mexico, Nevada, and Texas.
What We Repair
Tanks & Vessels
- Surface crazing and gel coat repair
- Structural crack repair with laminate rebuild
- Partial and full section replacement
- Manway and cover repair or replacement
- Floor and bottom section repair
- Roof repair on covered tanks
- Outlet sump repair
- Anchor lug and lifting lug repair or replacement
- Tank retrofit and reconfiguration
- Tank removal and decommissioning
Scrubbers & Scrubber Towers
- Tower shell structural laminate repair
- Internal packing bed support repair
- Mist eliminator repair and replacement
- Spray nozzle header and distribution system repair
- Gas inlet and outlet nozzle repair
- Sump section repair
Barges & Floating Pump Stations
- Hull integrity repair and delamination sealing
- Flotation chamber repair
- Pump mounting platform repair
- Mooring and attachment point repair
Linings & Chemical Barriers
- Corrosion barrier and chemical liner restoration
- Corrosion-proof lining installation
- Fitting, nozzle, and penetration repair or replacement
- Delamination stabilization
General FRP Systems
- FRP duct repair and reinstallation
- Pipe and fitting repair
We Service What We Didn't Build If you've inherited equipment from a prior contractor, acquired assets through a site purchase, or simply can't reach the original fabricator, we can assess, document, and restore your system to full operating specification.
Repair work is conducted in accordance with ASME RTP-1, FT&V RP 2007-1, and applicable EPA and OSHA requirements, with full before-and-after photo documentation on every job.
